Product

Automatic Chip Compactor
SCP-100H/103H

SCP-100H
amada metal cutting rotary pipe cutter SCP-100H

 

Features

Automatic chip compactor

  • This model is capable of briquetting and compacting chips ejected from metalworking shops, which makes a great contribution to a clean environment and the effective use of resources in the metalworking plant. Cutting fluid can also be collected at the same time for reuse. This model is the best choice for ISO14001 promotion programs and green accounting.

Area saving to 1/5 to 1/50

  • Space required for chip storage can be saved in the metalworking plant, and chip transport costs can also be reduced.

5% to 10% water content remains (Briquette weight ratio)

  • It is no longer sticky, and the factory to clean.

Introduction of original hopper (patented)

  • AMADA MACHINE TOOLS' patented original hopper eliminates the need of a crusher and prevents bridging and chip deposits on the hopper wall, and can cover various shapes of chips.

* SCP-103H is characterized by the higher output power of a hydraulic pump than SCP-100H for the purpose of increasing efficiency. Efficiency is approximately 1.5 times higher when handling short chips such as cast chips and band-sawn chips. SCP-103H is designed for users who desire to compact a large volume of ejected chips (same compacting force and finished products).

Comparison table
Shape, Material Finely chopped chips Spiraled chips Long and entangled chips
Finely chopped chips Spiraled chips Long and entangled chips
Iron, Steel
Stainless steel ×
Special steel,
Heat resisting steel
×
Aluminum

 

Specifications

  SCP-100H SCP-103H
Press force (kN) 980 980
Processing capacity* (kg/hours) 80 120
Compacted briquette diameter (mm) φ80 φ80
Compaction pressure (MPa) 195 195
Hopper capacity (L) 100 100
Hydraulic tank capacity (L) 150 300
Motors (kW) Hydraulic pump 5 7
Vertical screw 0.75 0.75
Horizontal screw 0.4 0.4
Lubricating oil pump 0.01 0.01
Power requirement (kVA) 9 12
Machine dimensions* (W x L x H) (mm) 920 x 2160 x 2048 994 x 2530 x 2332
Mass of machine (kg) 1860 2200

* Compacting capacity will vary depending on the material and condition of chips.

* A crusher may be necessary depending on the curled-shape chip.

* The machine height does include that of the signal tower.

* The following items cannot be compacted.

  • Burnt chip (over HRC25)
  • Extreme curled-shape chip
  • Explosive or naturally combustible items (such as magnesium)
  • The screw or the sleeves may be damaged if the following are process (such as bolt, bite, or remnants)
  • Untreated medical waste

These specifications and machinery and equipment appearance are subject to change without notice for reason of improvement.
This products is for Japan domestic market.

Back To Top